Epoxy system R2940 / H9052 (Slow)

Structural epoxy system R2940 / H9052 for Vacuum infusion and RTM with slow hardener

Each kilo includes 0.74 kg resin + 0.26 kg hardener

Two component epoxy system, specially designed for Resin Transfer Molding process, vacuum infusion, injection, etc. It may also be used in hand layup (for flat surface molds or molds with no vertical surfaces). It exhibits very high mechanical properties, especially interlaminar shear strength. This system has a very low viscosity, and low reactivity for manufacturing of large parts. It also exhibits excellent retention of the mechanical characteristics in a wet environment. Temperature resistance: Tg1 max = 100 ^oC

PROPERTIES
Physical properties of R2940 epoxy resin:
Aspect / colour: Yellowish liquid
Viscosity (mPa.s) at 20 ^oC: 1700 (+-200)
Density (g/cm3) at 20 ^oC: 1.15 (+-0.01)

Physical properties of H9052 hardener:
Aspect / colour: Light yellowish liquid
Viscosity (mPa.s) at 20 ^oC: 20 (+- 5)
Density (g/cm3) at 20 ^oC: 0.937 (+- 0.010)

Mix properties of R2940 / H9052 system:
Mix viscosity (mPa.s) at 20 ^oC: 500 (+-50)
Mixing ratio by weight: 100 g / 35 g
Mixing ratio by volume: 100 ml / 43 ml

Reactivity of R2940 / H9052 system:
Pot life on 500 g mix at 20 ^oC: 5 h 25'
Exothermic temperature (^oC) on 500 g mix at 20 ^oC: 177
Time to reach the exothermic peak on 500 g mix at 20 ^oC: 6 h

Polymerisation of H9052 hardener:
Time to wait at 20 ^oC before post-curing*: 20 hours
Minimum post-cure cycle: 20 hours at 50 ^oC
Advised post-cure cycle: 16 hours at 60 ^oC

*has to be respected in case of thick laminate (> 3 mm,) so to limit the risk of exothermic reaction.

For detailed data sheet please contact.



Intrastat Number for this product: Epoxy: 39073000, Hardener: 29213091